Archive: Commercial Grade - How to: Drain the water

How to successfully drain the water when cleaning the bath

This guidance is for: Commercial Grade models shipped before March '24 which are identifiable by the filtration type. Your Commercial grade unit will have dual filtration with an 80 & 20 micron filter. 

For PRO Models shipped after March '24 - head over to the guidance here

There are two ways you can do this:

1. Use a submersible pump attached to a hosepipe
2. Use the drain point as detailed below

Pull the nozzle until it is fully extended out and then remove the cap on the end.
Attach the hose pipe fitting that you received with the bath and attach a hosepipe, of which the other end is in a suitable location to drain the water.
Push the nozzle back in just until you feel resistance. The bath will now begin to drain.

You can then attach the end of the hosepipe to a water supply to enable you to refill the bath with clean fresh water.

If you require assistance:

Feel free to reach out to our team for support

Drop us a line by clicking here

Or you can call us on +441135267255 during our operating hours:

Monday to Friday from 09:00am to 17:30pm.