WATER TOP UP
1. Activate MAINTENANCE MODE (Press and hold spanner on control panel)
2. Open FILL TAP to let water in. Close when water level up to MIDDLE OF SKIMMER
3. Exit MAINTENANCE MODE (Press and hold spanner on control panel)
4. CHECK the bath is running: Light illuminated and water flowing
BACKWASH THE MEDIA FILTER
1. Activate MAINTENANCE MODE (Press and hold spanner on control panel)
2. Depress the MEDIA FILTER HANDLE Turn to the BACKWASH position.
3. Activate BACKWASH MODE (Press and hold the down arrow on control panel)
4. Allow the backwash to run until SIGHT GLASS RUNS CLEAR. Or if not clearly visible, flush up to a maximum of 2/3rd of the water from the bath.
5. To stop, activate MAINTENANCE MODE (Press and hold spanner on control panel)
6. Depress the MEDIA FILTER HANDLE Turn to the RINSE position.
7. Activate BACKWASH MODE (Press and hold the down arrow on control panel)
8. WAIT 60 SECONDS Then activate MAINTENANCE MODE (Press and hold spanner on control panel)
9. Depress the MEDIA FILTER HANDLE Turn to the CLOSED position.
10. Open FILL TAP Close when water level up to MIDDLE OF SKIMMER
11. Depress the FILTER HANDLE Turn to the FILTER position.
12. Exit MAINTENANCE MODE (Press and hold spanner on control panel)
13. CHECK the bath is running: Light illuminated and water flowing
DRAIN & FILL
1. BACKWASH media filter - follow backwash procedure UNTIL STEP 9 (Media filter in closed position)
2. POWER DOWN the bath
3. Open DRAIN VALVE Until bath is EMPTY
4. Clear any debris and fully CLEAN
5. Close DRAIN VALVE
6. Open FILL TAP Close when water level up to MIDDLE OF SKIMMER
7. Depress the FILTER HANDLE Turn to the FILTER position.
8. POWER UP the bath
9. CHECK the bath is running: Light illuminated and water flowing