A step by step guide on how to change the particle filter.
To carry out a filter change, follow these steps:
- Remove the vented access panel
- Enter maintenance mode by pressing and holding the spanner button for 3 seconds
- Isolate the main filtration unit using the isolation valves by turning the two blue handles 90 degrees clockwise to the of position
- Loosen the filter housing by using the provided spanner and then proceed to remove the plastic filter housing. Beware you may experience some water loss whilst changing the filter
- Empty the water and dirty filter from the filter housing. You can now clean and sanitise the housing using an anti-bacterial solution
- Replace the 20 micron particle filter with a clean one.
- When re-fitting ensure the large O ring on the filter housing is in place and tighten the filter housing with the plastic spanner provided until secure.
- Open the isolation valves again, 90 degrees anti clockwise to the open position.
- Ensure that the filter housing fills with water and then bleed the filter by pressing the red button on the top of the filter.
Video guide