Your plunge has a control panel in the compartment area.
| Temperature |
The display on the control panel shows the current temperature, until the up or down keys are pressed when the target temperature is displayed. |
| Temp Down | The lowest temp setting is 3°C for chill products, 0 for ice products. Please note, when changing the target temperature, the chilling function may take a few minutes to restart. |
| Temp Up | The highest temperature setting is 10°C. Note: the plunge will not heat up, if you toggle temp up it will stop cooling and the water will naturally get warmer. |
| Backwash mode (Temp Down long press) | Press and hold the Temp Down arrow for 3 seconds to put the bath into a backwash mode - This turns the cooling engine off (on plunges with a chiller engines) while keeping the pump running. This is important to protect plunges with a chiller engine while backwashing. |
| Backwash mode (Temp Down long press) | Press and hold the Temp Down arrow for 3 seconds to put the bath into a backwash mode - This turns the cooling engine off (on plunges with a chiller engines) while keeping the pump running. This is important to protect the chiller while backwashing. |
| Maintenance Mode (Spanner) | Press and hold for 3 seconds to put the bath into a maintenance mode - The LED light on the chiller and light in the barrel will flash 3 seconds on 3 seconds off whilst in this mode. From here you can change the particle filter. Exit maintenance mode by pressing and holding for 3 seconds again. |
| START | This function is for our residential range to turn the light on in the plunge. Not applicable for PRO range |
| DEFROST | This function is for ice baths only, and should only be used if ice ever becomes stuck on the bottom of the plunge |