NB. This guidance is for our new Brass Monkey Barrel & Chiller product, designed and assembled by our team in the UK. If you bought a Barrel & Chiller before 2024, refer to our archive for user guidance for 'Tuya Chillers'
Meet your Brass Monkey Barrel
Meet your Brass Monkey Chiller
| 1. | Power Cable | Cable with inline RCD protector |
| 2. | Maintenance Access | Removable panel to gain access for maintenance tasks |
| 3. | Outlet Connector | Where water flows out of the chiller towards the barrel |
| 4. | Inlet Connector | Where the water flows from the chiller into the barrel |
| 5. | Barrel Light Socket | Connection point for the light cable to power the light inside the barrel |
| 6. | Control Panel | Controls the chiller and displays your unique bath ID. QR code to pair with the app |
| 7. | UV Filter | UV steriliser to keep the water disinfected |
| 8. | Dip Session Button / LED Light | Button to start a dip (turns off the chiller for 20 mins) |
| 9. | Particle Filter Housing | Sediment removal filter |
| 10. | Drainage Isolation Valve | This valve drains water out of the chiller, connect a hosepipe to drain the water |
Safety first
- Leave your chiller unplugged until the setup is complete and you are instructed to power up.
- Your power socket must be earthed and RCD protected. Under no circumstances should you ever use an adaptor or extension lead.
- The inline RCD is there as an additional level of protection. Primary protection should be within your home’s electrical circuit.
- Only use this product if you feel well and physically capable. Consult your doctor if you are unsure.
- This product is not for children. Always ensure small children are supervised near the barrel.
Check the power socket
Your barrel chiller has been individually tested for safety before leaving our workshop. However, we can’t account for where the units are plugged in. This is why we ask you invest a few minutes to double-check the safety of the power socket you intend to use to power your Brass Monkey.
It is your responsibility to ensure your barrel chiller is plugged into a socket with:
- an earthed electrical supply
- 30mA RCD (residual current device) protection
- an IP rated waterproof cover
To help, in your starter pack we included a Smart Socket Tester. Follow the instructions provided with the tester to check your socket is safe.
If the socket is good, continue with setup. If it fails or you are still unsure, speak to an electrician before going any further. Under no circumstances should you ever use an adaptor or extension lead. If you need a power socket closer, speak to an electrician.
Check your barrel & chiller position
Before commencing setup, check you have your barrel & chiller in the correct position:
Location: Your barrel is intended for outdoor use only. Note condensation may occur from time to time leaving water on the floor.
Surface: Your barrel is heavy, especially when full of water. It needs to be sat on a hard and flat surface capable of holding 610kg.
Ventilation: Your barrel has vents on 2 sides, these will need to sit 30cm clear of any obstruction to allow the air to flow.
Access: You’ll need to access inside the chiller via the side panel. Ensure you’ll have space to remove the panel and undertake maintenance tasks.
Water: Your barrel will need filling with fresh tap water (never fill from a swimming pool or other water source), so make sure your bath is placed in reach of a hose.
Signal: Your chiller comes ready to be connected to your Wifi network. It will need to sit within range of a strong 2.4Ghz Wifi signal on a private home network.
Setup
Your barrel is up and running!
It can take up to 24 hours to cool the water down to your target temperature.
See bath controls to learn how to set the temperature.
Use the app to connect your bath to wifi.