Familiarise yourself with the key components of your unit. Depending on its configuration (layout, standalone, or plant room-based), the location of these components may vary.
|
1. Water skimmer |
The always-on skimmer gently draws the water through a narrow opening, removing debris from the surface. |
|
2 & 3. UV light filter & micro doser |
The water is passed through a UV light chamber, killing pathogens for a deeper clean. This is also where the micro doser is stored and activated. It dispenses a safe, minute dose of your preferred solution, killing bacteria for fresh, clear water. A digital screen below allows you to set your microdose. It also shows when your UV bulb next needs changing. |
|
4. Media filter |
Water is flowed through the media filter, removing fine sediment and organic materials, collecting the finest particles in the water for ultimate water clarity and member safety. |
|
5. 1HP ice maker |
Connected to the sides of the plunge by copper pipework using gas to super cool the sides of the bath and form ice under 3 degrees. For plant room installs we would move this on top of the 2HP chiller. |
|
6. 2HP chiller |
High powered chiller that allows quick cooling to the water. Water passes into the heat exchanger after filtration and travels back to the plunge via an insulated PVC pipe. |
|
7. Electronics box |
Housing our custom PCB, it has six sensor inputs from the plunge and equipment and supplies power to the various components controlled via our software. The Wifi aerial is also housed here. A dual engine setup would contain two go these. |