SPA RANGE: The Control Panel

1 

Temperature

The display on the control panel shows the current temperature, until the up or down keys are pressed when the target temperature is displayed.

Temp down

The lowest temp setting is 3°C for chill products,
0 for ice products. Please note, when changing the target temperature, the chilling function may take a few minutes
to restart.

Temp up

The highest temperature setting is 10°C. Note: the plunge will not heat up, if you toggle temp up it will stop cooling and the water will naturally get warmer.

Backwash mode (temp down
long press)

Press and hold the temp down arrow for 3 seconds to put the bath into a backwash mode - This turns the cooling engine off (on plunges with a chiller engines) while keeping the pump running. This is important to protect plunges with a chiller engine while backwashing.

Maintenance mode (spanner)

Press and hold for 3 seconds to put the bath into a maintenance mode - The LED light on the chiller and
light in the bath will flash 1 flash - 1 second gap - 1 flash whilst
in this mode. From here you can change the particle filter.
Exit maintenance mode by pressing and holding for
3 seconds again.

Start

This function is for our residential range to turn the light on in the plunge. Not applicable for Commercial Range.

Defrost

This function is for ice baths only, and should only be used if ice ever becomes stuck on the bottom of the plunge.

Bath light

The light in the bath and the light on the front of the electronics box will remain on even when not in use.
The light will flash when in maintenance/backwash mode. If the light flashes when not in one of these modes see the trouble shooting section and contact the CX team.