Your chiller has a control panel in the compartment area.
| Temp Display | Displays the current temperature. Press to take the target temperature down. Please note this display has no decimal point. So 10°C is displayed as 100. |
| Temp Down | The lowest temp setting is 3°C displayed as 30. Please note, when changing the target temperature, the chilling function may take a few minutes to restart. |
| Temp Up | The highest temperature setting is 10°C. Note: the barrel will not heat up, if you toggle temp up it will stop cooling and the water will naturally get warmer. |
| Maintenance Mode | Press and hold for 3 seconds to put the bath into a maintenance mode - The LED light on the chiller and light in the barrel will flash 3 seconds on 3 seconds off whilst in this mode. From here you can change the particle filter. Don't forget to exit maintenance mode by pressing and holding for 3 seconds again. |
| Setting a schedule within the app | Setting a schedule for your barrel using this app is the most energy efficient way to run your barrel. While sat idle, all that needs to run is the pump to keep the water clean rather than constantly using energy to cool. |
| DEFROST | This function is for ice making baths only. This function is not applicable to barrel chillers. |
Use the App for easy chiller control and troubleshooting tips. See the guide here.