How to: replace the particle filter

A step by step guide on how to change the particle filter.

This guidance is for: PRO Grade models shipped after March '24 which are identifiable by the filtration type. Your PRO grade unit will have a 20" filter and a twistiiclean backflush. 

For PRO Models shipped before March '24 - see guide here

To carry out a filter change, follow these steps:

1. Remove the vented access panel
2. Enter maintenance mode by pressing and holding the spanner button for 3 seconds
3. Isolate the main filtration unit using the isolation valves by turning the two blue handles 90 degrees clockwise to the of position
4. Loosen the filter housing by using the provided spanner and then proceed to remove the plastic filter housing.  Beware you may experience some water loss whilst changing the filter
5. Empty the water and dirty filter from the filter housing.  You can now clean and sanitise the housing using an anti-bacterial solution
6. Replace the 20 micron particle filter with a clean one.
7. When re-fitting ensure the large O ring on the filter housing is in place and tighten the filter housing with the plastic spanner provided until secure.  
8. Open the isolation valves again, 90 degrees anti clockwise to the open position.
9. Ensure that the filter housing fills with water and then bleed the filter by pressing the red button on the top of the filter
   

   Video guide